Search Laptop Screens >>

Tuesday, 2 August 2011

Packard Bell Dot S S2 SE PAV80 Netbook Screen Replacement

In this tutorial I will show you how to disassemble and replace a broken LCD screen on Packard Bell Dot S and Dot SE PAV80 Netbook laptops. The Packard Bell Dot S, S2 and Dot SE PAV80 Netbook come with slimline 10.1 inch widescreens. This replacement instruction is brought to you by Laptop Screen Online, leading supplier of replacement laptop screens in Europe.


Packard Bell Dot S Laptop

The Packard Bell Dot S, S2 and Dot SE PAV80 Netbook replacement is very close and similar to the Acer Aspire One D255 screen replacement technique and also comes with the same slimline WSVGA 10.1 screen with a resolution of 1024 x 600.

This same instruction applies if your screen has gone dark, flickering or cracked.

Packard Bell Dot S Netbook With Broken Screen

Before starting the screen repair it is best to first order the replacement screen. This is not hard as the Packard Bell Dot S screen are only one type with part number of B101AW06 V.1.

First remove the battery from the netbook before starting the repair.

The Packard Bell Dot S S2 SE PAV80 Netbooks usually come with the information sticker in the battery enclosure area at the bottom of the laptop. This is revealed after the battery is removed.

Use a flat screwdriver to remove the plastic screw covers on the lower sides of the netbook plastic bezel.

Remove the two screws after removing the covers.

Remove the plastic bezel. The trick is to put your fingers between the screen and the bezel and pull on all sides.

In the internal part of the screen unscrew only the screws holding the screen to the bracket. Use the image on the right as a guide. Keep the screws safe.

At this point remove the camera cable and remember to put during the new screen installation.

Place the Packard Bell Dot S netbook screen face-down on the keyboard area. At this point you will be able to see the screen part number.

Peel up the clear tape holding down the screen cable connector and disconnect it from the port.

Congratulations! At this point you would have successfully removed the Packard Bell laptop screen. Install a new display panel by continuing the process in reverse.

Thank you. Leave all your questions about the screen monitor and the instruction below.


Nice write up and very handy thanks!

That camera connection is super tiny, and a bit of a fiddle!

Thank you Chris. The Packard Bell Dot S S2 SE PAV80 Netbook camera connection is very small indeed and requires a careful handling. I am glad blog it is of help to you.

Hi, my screen seems to be joined by some metal tape. Is it ok to cut through this?

Yes it is ok ok to cut it off without damaging the display cable.

Post a Comment

Write your comments and questions about Laptop Screen Replacement.